What is the purpose of pocket doors?

A pocket door is a sliding door that, when fully open, disappears into a compartment in the adjacent wall. Pocket doors are used for architectural effect, or when there is no room for the swing of a hinged door. They can travel on rollers suspended from an overhead track or tracks or guides along the floor.

How much space is needed for a pocket door?

A pocket door requires a “sleeve” inside the wall to retract into. For a traditional 32-inch-wide interior door, you’ll need at least 66 inches of linear wall space: 32 inches for the door and the rest for the housing.

Are pocket doors OK for bedrooms?

Pocket doors are a good option for smaller rooms that may not have space for a full-swing door. They’re perfect for closets, connecting two spaces (for example between an en suite and a walk-in closet, and small bedrooms where floor space counts.

Are pocket doors expensive?

Pocket Doors Cost During a new construction, pocket doors will cost between $500 and $1,000. As part of a remodeling project, their cost will be in the $1,000 to $3,500 range. These prices reflect both parts and labor. These doors hide inside a wall cavity instead of swinging out from a hinge.

Can you put a pocket door in an existing wall?

To install a pocket door in an existing wall, you have to remove drywall, and it’s easier to uncover the entire wall instead of trying to work in a limited opening. You’ll need to set new king studs and trimmers, place the header and install cripple studs between the header and the top plate of the wall.

What is the rough opening for a pocket door?

Determining what size to make rough openings for single pocket door framing is a simple process. Almost all hardware manufacturers state in their instructions, width of the rough opening is two times that of the door plus one inch and the height is seven feet one inch.

Can you use a regular door for a pocket door?

As long as the measurement is correct for the pocket opening, the door is the right thickness, and the door hasn’t been pre-drilled for a standard door lockset or hinges, you can use any kind of door for a pocket door.

Can you use an existing door for a pocket door?

As long as the measurement is correct for the pocket opening, the door is the right thickness, and the door hasn’t been pre-drilled for a standard door lockset or hinges, you can use any kind of door for a pocket door. Just drill and mortise the new door to accept the pocket door hardware, hang it on the pocket door slide, and you’re good to go.

How do you install a pocket door frame?

How to Install a Pocket Door: 1. Construct Rough Opening (Tear out everything existing and rebuilt a new frame and threshold, possibly relocated electrical) 2. Measure for Header Frame End Brackets (Hammer in 2 nails) 3. Snap a Chalk Line 4. Attach Frame Header to Rough Studs (Hang the pocket door contraption)

What is the size of a double pocket door?

Standard door widths range from 24 inches to 32 inches. Double the width of the desired door, or pair of doors, to determine the wall space that’s needed to install the pocket door frame. For example, 48 inches is needed to install the frame for a 24-inch door. For double doors, double the width of one door and multiply the result by two.

What are the dimensions of a pocket door?

Measuring for a pocket door is based on the size of the door opening, the wall area needed to install the frame and the width of the studs in the wall. Determine the size of a single door or pair of double doors that suits your purposes. Standard door widths range from 24 inches to 32 inches.