What are the dimensions of forklift forks?

Length of fork (L) – measure from the end of the tip to the shank. Length can be given in mm or inches, common lengths are 48” inch, 72” inch and 96” inch. Width (W) = width of the fork at its widest point. Thickness (T) = thickness of the forks is measure on the shank.

How many inches should forks be when driving forklift?

Keep the forks 6 to 10 inches above the ground to avoid potential hazards on the ground. Remember that forklifts are top-heavy. Carry the load low and tilted back.

Are all forklift forks the same?

People who don’t work with forklifts all the time often assume that there is only one type of forks that fit onto lift trucks. There are actually many different types of forks, most of which are interchangeable depending on how you plan to use your forklift.

Are forklift forks standardized?

ANSI (The American National Standards Institute) has published standard number B56 11.4 revision 2013 entitled “Hook type forks and fork carriers for powered industrial fork trucks.” This standard encompasses standards relating to hook type forks up to 24,000 pound lifting capacity.

How long is a standard dinner fork?

7 inches
Dinner forks measure between 6 and 9 inches long, with 7 inches being a common length in many collections. The dinner fork uses long tapered tines designed to spear pieces of solid food.

How far apart should forks be spaced?

For handling pallets, ideally your forks should be spaced equally apart center to the carriage/backrest, around 10 inches out from each side. But really there is no exact measurement; the best rule is to space them just a bit less from as wide as you can have them for the pallets/loads you will be handling.

How do I check my forks?

Fork Inspection: Check Fork Blade Wear Place the caliper onto the blade at the point of the fork that receives the most wear, which is usually at its heel, as shown. If the blade passes the inside teeth of the caliper, then the fork is out compliance and must be tagged out until forks are replaced.

What is the length of trucks on a forklift?

three truck lengths
A safe distance shall be maintained approximately three truck lengths from the truck ahead, and the truck shall be kept under control at all times.

What is the standard forklift width?

between 4 to 7 ft wide
Standard forklifts generally measure between 4 to 7 ft wide and 8 to 10 ft long. Outdoor or rough terrain forklifts can be greater than 10 ft in length.

How long is a fork in inches?

The dinner fork measures about 7 inches in length.

What are the dimensions of a standard forklift?

Forklifts range in size depending on their function. Although they are versatile machines, you’ll need the right size for the job. Standard forklifts generally measure between 4 to 7 ft wide and 8 to 10 ft long. Outdoor or rough terrain forklifts can be greater than 10 ft in length.

How wide are forklift Forks?

Measure the forks for length, width, and thickness. The thickness tends to be the same—roughly two inches. However, the width and length can vary. Forklift blades come in four, five, and six inch widths.

What is standard forklift Fork width?

Below are most of the forklift categories and a general estimate of the length and width of each type. Standard – typically the trucks with a standard width will be class 1, 4, or 5 and will measure in between 4 to 7 feet (it may vary more and less).

What is standard size Fork?

The average length of a standard dining fork is close to 7 inches. Aside from this, there are smaller variants, most of which are approximately 6 inches in length. Sizes usually vary depending on the type of fork.