How do I reset my Taylor Digital scale?

The following reset procedure is used when the scale shows an err2, err, 0.0, inaccurate weight, or some other unusual error.

1. Remove the battery from the scale.
2. Sit the scale on a hard surface floor.
3. Step up onto the scale, stand still for about 5 seconds and step off the scale.
4. Re-install your battery.

Why is my Taylor scale inaccurate?

Your digital scale may show an error message or an inaccurate reading if the unit is overloaded. Each scale has a maximum weight capacity, so if the user weighs more than the maximum, the scale is unable to provide a weight. Immediately remove the weight or you may do permanent damage to the scale.

How do you use the Taylor gram scale?

FAQs – Scales

1. Place the scale back on a hard surface floor.
2. With one foot only, place just enough weight on the scale for the display shows zero’s or dashes. Once you see zeros or dashes remove your foot.
3. Wait for the scale to turn off again.
4. Step up onto the scale for a weight.

How do you calibrate a digital scale?

Set the scale on a flat, level surface and turn it on. Wait a few moments for the scale to stabilize its readings. Locate the calibration switch (some scales require a sequence of numbers on the control panel) and activate the calibration mode. Place the quarter on the center of the scale and check the reading.

How do I calibrate a Taylor scale?

Remove the battery from the scale. Set the scale on the floor (no carpet) without the battery in place. Stand on the scale for 10 seconds (still without the battery). Carefully replace the battery without pressing any buttons or activating the scale.

Are Taylor body fat scales accurate?

The scale measures fat, body water and muscle mass composition accurate to . 1%. Able to store up to four measurements in memory to help track individual weight loss efforts.

How do I change my Taylor food scale to grams?

1. Place the scale on a hard, level surface.
2. Press the “ON/OFF” button to turn the scale on. The display first shows.
3. Your scale is set at the factory to weigh in ounces. To switch to grams,
4. Place the item to be weighed on the center of the platform.
5. The scale will turn off automatically after 1½ minutes of non-use.

How do you calibrate a digital scale without weights?

First, turn the power on, then press the “Zero” or “Tare” button if there is one present. Wait patiently while the scale clears any remaining data from previous uses. It may take a second, but your scale should show a “0.00” weight once it is zeroed.